Jump to content

Turbidity meter: Difference between revisions

From (art)scienceblr
imported>Shreyasi
No edit summary
No edit summary
 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
With Tasneem we made a simple turbidity meter using an LDR and laser.
'''This is a simple Turbidity meter with a Light Dependent Resistor and a Laser'''


[[File:Turbidity 1.jpg|750px]]
[[File:Turbidity 1.jpg|750px]]


Materials needed -  
'''Materials needed''' -  


1. LDR  
1. LDR  
2. Laser Pointer  
2. Laser Pointer  
3. 33k Resistor
3. 33k Resistor
3. Dark tube/Box (We used a black pvc pipe)  
 
3. Dark tube/Box (We used a black pvc pipe)
4. Arduino + usb cable
4. Arduino + usb cable
5. Wires  
5. Wires  
6. test tubes  
6. test tubes  


Tools -
Tools -
1. Soldering Iron + Solder  
1. Soldering Iron + Solder  
2. Glue Gun  
2. Glue Gun  
3. wire cutter/stripper   
3. wire cutter/stripper   




1. Connect one leg of the LDR ground on the arduino . The other leg of the LDR will go to analog input 0 (Any of the analog inputs can be used.  
1. Connect one leg of the LDR ground on the arduino . The other leg of the LDR will go to analog input 0 (Any of the analog inputs can be used.  
2. Connect one leg of the resistor to +5V on the arduino. The other leg of the resistor will go to the same analog input as the LDR (A0 in this case). This forms a [https://en.wikipedia.org/wiki/Voltage_divider| potential divider.]
2. Connect one leg of the resistor to +5V on the arduino. The other leg of the resistor will go to the same analog input as the LDR (A0 in this case). This forms a [https://en.wikipedia.org/wiki/Voltage_divider| potential divider.]

Latest revision as of 06:39, 4 April 2016

This is a simple Turbidity meter with a Light Dependent Resistor and a Laser

Materials needed -

1. LDR

2. Laser Pointer

3. 33k Resistor

3. Dark tube/Box (We used a black pvc pipe)

4. Arduino + usb cable

5. Wires

6. test tubes

Tools -

1. Soldering Iron + Solder

2. Glue Gun

3. wire cutter/stripper


1. Connect one leg of the LDR ground on the arduino . The other leg of the LDR will go to analog input 0 (Any of the analog inputs can be used.

2. Connect one leg of the resistor to +5V on the arduino. The other leg of the resistor will go to the same analog input as the LDR (A0 in this case). This forms a potential divider.