Turbidity meter: Difference between revisions
Appearance
imported>Shreyasi Created page with "Making turbidity meter with Tasneem ." |
No edit summary |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
'''This is a simple Turbidity meter with a Light Dependent Resistor and a Laser''' | |||
[[File:Turbidity 1.jpg|750px]] | |||
'''Materials needed''' - | |||
1. LDR | |||
2. Laser Pointer | |||
3. 33k Resistor | |||
3. Dark tube/Box (We used a black pvc pipe) | |||
4. Arduino + usb cable | |||
5. Wires | |||
6. test tubes | |||
Tools - | |||
1. Soldering Iron + Solder | |||
2. Glue Gun | |||
3. wire cutter/stripper | |||
1. Connect one leg of the LDR ground on the arduino . The other leg of the LDR will go to analog input 0 (Any of the analog inputs can be used. | |||
2. Connect one leg of the resistor to +5V on the arduino. The other leg of the resistor will go to the same analog input as the LDR (A0 in this case). This forms a [https://en.wikipedia.org/wiki/Voltage_divider| potential divider.] | |||
Latest revision as of 06:39, 4 April 2016
This is a simple Turbidity meter with a Light Dependent Resistor and a Laser
Materials needed -
1. LDR
2. Laser Pointer
3. 33k Resistor
3. Dark tube/Box (We used a black pvc pipe)
4. Arduino + usb cable
5. Wires
6. test tubes
Tools -
1. Soldering Iron + Solder
2. Glue Gun
3. wire cutter/stripper
1. Connect one leg of the LDR ground on the arduino . The other leg of the LDR will go to analog input 0 (Any of the analog inputs can be used.
2. Connect one leg of the resistor to +5V on the arduino. The other leg of the resistor will go to the same analog input as the LDR (A0 in this case). This forms a potential divider.